NESTEC will be exhibiting at the USIPA conference on October 2nd through October 4th, 2022. NESTEC will be located at booth #27.
We hope to see you there!
- James Nester……………..C 215 565 6189
- Jaymie Deemer………….C 616 970 4505
- Kendahl Nester……….C 267 421 6183
- Rodney L Pennington…C 407 492 1955


AGENDA

Successful, energy saving RTO/RCO installations with substantial process CO2 reductions
Since early 2010, RTOs have been used in the wood pellet industry to control air emissions from the dryer and/or hammer mill and pellet mill exhaust.
NESTEC has installed twelve complete air emission control systems RTOs, RCOs, and WESPs, including the process exhaust collection and control systems for the wood pellet industry. NESTEC systems were installed for energy conservation and control on the rotary wood chip dryer exhaust and/or hammermill and cooler processes in MS, LA, GA, TX, and NC.
NESTEC’s APC installation at a Wood Pellet facility reduced the potential CO2 by 1,500 lbs per hour or 6,000 tons per year, in addition to reducing the operating costs with a savings of $600,000 per year.

A typical NESTEC total process duct collection system and RCO arrangement is shown below. The process exhaust is controlled through two parallel NESTEC MCC RCO units with a single exhaust stack.

NESTEC, Inc. provides experienced, reliable, and proven single point responsibility for installation, services, training for all RTO, RCO, WESP systems, with 24 – 7 responses.
For assistance from our extensive experience, call or e-mail NESTEC Inc. (Office: 610-323-7670) for a free evaluation of your specific needs.
jnester@NESTECinc.com (Sales)
jdeemer@nestecinc.com (Sales)
wholden@nestecinc.com (Service, Aftermarket)
Leave a Reply